Introduction
We built this little heater for the moments when you need serious heat in a seriously tight spot. Think of it as a compact powerhouse—a 400V, 2500W halogen shortwave lamp designed to blast focused warmth exactly where you need it, when you need it. Fast.
The Inside Story
Here’s the thing about the 400V design: it plugs straight into your standard industrial power. No need for clunky transformers. That means cleaner wiring and a footprint that stays small. The 300mm length? That wasn’t an accident. It’s just long enough to cover the area you need, but short enough to fit where space is at a premium. It heats up fast—seriously fast—so just make sure your machine’s cooling can keep up with the extra warmth.
Built to Last
We wrapped the whole thing in a quartz tube. Why? Because it handles the shock of going from cold to hot, over and over again, without flinching. And it’s a champ at sending out that shortwave infrared heat. Inside, the halogen gas does its job quietly, keeping the filament stable. So the heat stays consistent, and the lamp lasts longer. And the R7s connector? It’s a straight-forward, two-pin setup. Seriously, you just wire it, line up the pins, and snap it in. No messing around with complicated terminals. It’s a true drop-in replacement.
Why It Works for You
This is for the engineer who needs to heat up a small enclosure or pre-heat a part, and can’t afford to wait. The shortwave heat gets right to work, penetrating surfaces quickly and shaving time off your cycles. It’s small enough to fit where bigger heaters can’t even dream of going. Just keep in mind: it’s a lot of power in a small package. So you’ll want to make sure the components around it can handle the heat. But for getting heat exactly where you need it, when you need it? It’s the practical solution you’ve been looking for.